Most of our Uniontown calls come from Main Street and the AL-61 corridor, though we work the whole Perry County side of it and get out to Marion regularly.
Door problems in Uniontown tend to sort into two groups: older homes where the frames and jambs have taken decades of weather, and newer builds where the hardware was the cheapest part of the package and has already given up.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895Common door closer repair faults in Perry County
These are the door closer repair faults we are called out to most often in Uniontown. If you recognise one, the underlying cause is usually the second half of the line.
- The closer arm is bentThe door has been forced open past its stop, usually by wind or by a cart.
- A fire door that stays openSerious safety issue: failed closer or a hold-open that should be releasing.
- The closer works well cold and slams when hotFluid thinning with temperature in a unit whose valves can no longer compensate.
- The door closes at a good speed then slams the last inchLatch speed set too fast, or a worn valve that no longer holds the latch adjustment.
- The door slams open against the wallBackcheck has failed or is not adjusted, and the arm and frame are taking the impact.
- There is a knock at the end of the opening swingNo backcheck, or backcheck that has failed, so the arm is bottoming out.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895Uniontown conditions and door closer repair
Black Belt soil is the reason so many doors in this part of Alabama do not close right. That dark prairie clay swells dramatically when saturated and shrinks in a dry August, and a house sitting on it moves with it.
Water running down a door face and into a surface closer body corrodes the internals and the mounting fasteners, and a closer that has been wet repeatedly usually fails at the seal.
When a frame moves with the ground under it, the door binds somewhere in its swing, and people compensate by cranking the closer tighter, which is why so many doors are simultaneously hard to open and still not latching.
It is why the same repair done properly in Uniontown lasts, and the same repair done cheaply does not.
Local factors we account for in Uniontown: heavy rainfall and soil movement — typical of the Black Belt.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895What we repair
- Surface closer replacementNew surface mounted closers sized correctly for door width and weight.
- Wind and stop protectionFitting overhead stops so wind cannot destroy the closer arm.
- Hold-open arm serviceRepairing and adjusting hold-open functions.
- Delayed action setupAdding delayed closing for accessibility so people have time to get through.
- Floor closer repairServicing and replacing floor-mounted closers under heavy entrance doors.
- Mounting repairRepairing or reinforcing door and frame where closer fasteners have pulled out.
- Arm and bracket replacementReplacing bent arms, broken forearms and failed mounting brackets.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895What happens when we get there
- Watch the door close, twiceThe speed of the last few inches and the first few tells us most of what we need to know before we touch a valve.
- Rule out the door before blaming the closerA door binding on the frame makes a perfectly good closer look weak, and turning the closer up is the wrong answer.
- Check for the simple faultsLoose arm fixings, a bent forearm or a seized pinion account for a lot of closers that look dead. On prairie clay we look at the whole opening for racking, because a door here is usually reporting a foundation movement rather than a hardware fault.
- Size the replacement properlyDoor width, weight and exposure decide the power size. An undersized closer will not shut the door; an oversized one shuts out anyone who is not strong.
- Set for people, not just for latchingThe door needs to close and latch every time and still be openable by someone with limited strength.
- Reinforce the mountingOn a hollow door we fit a backing plate rather than driving screws into a skin that will pull out again.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895What affects the cost of door closer repair in Uniontown
There is no single price for door closer repair in Uniontown, because two doors with identical symptoms can need very different work. Here is what makes the difference:
- adjustment versus rebuild versus full replacement
- fire rating and accessibility compliance requirements
- adding overhead stops or hold-open functions
- surface, concealed or floor mounted closer type
- the size and weight of the door and its exposure to wind
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Uniontown.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895Areas we cover for door closer repair in Uniontown
We work throughout Uniontown, including Main Street and the AL-61 corridor. If you are near the Uniontown historic district and the Black Belt prairie, that is inside our normal service area.
We also cover the nearby Perry County and the Black Belt communities listed further down this page.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895Door closer repair in Uniontown: questions we get asked
Our fire door is propped open. Is that a problem?
Yes, and it is one of the most common code violations we see. A fire door that cannot close and latch is not doing anything. If it gets propped because it is hard to use, that is the problem to solve.
What size closer do I need?
It depends on the door width, weight and exposure. Exterior doors in Perry County also need to handle wind, and an undersized closer on a windy exposure gets destroyed.
The closer arm on our door is bent. What causes that?
The door was opened past its limit, usually by wind catching it or by someone pushing it hard against a wall. Replacing the arm without adding an overhead stop just means it happens again.
My door does not close all the way. What is going on?
Either the closing force is too low, or the door is dragging on the frame in the last few inches. In Uniontown we see the second one often, because a frame that has moved makes a good closer look weak.
There is oil dripping from my door closer. Can it be refilled?
No. Closers are sealed units, and once the seal fails the closer is finished. Refilling is not possible on standard units and the unit needs replacing.
Can you make our door easier to open for accessibility?
Yes. Opening force can be adjusted, delayed action can be added, and if the door genuinely cannot meet requirements mechanically there are power operators. Getting the mechanical adjustment right comes first.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895Other door repair services in Uniontown
- Sliding Door Repair Uniontown
Sticking, jumping, or dragging sliding glass doors put back on smooth-rolling track.
- Door Lock Repair Uniontown
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair Uniontown
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair Uniontown
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair Uniontown
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair Uniontown
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Uniontown
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair Uniontown
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Storefront Door Repair Uniontown
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Automatic Door Repair Uniontown
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Uniontown
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Uniontown
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Uniontown
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Uniontown
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Uniontown
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Door Closer Repair near Uniontown
We cover the surrounding Perry County and the Black Belt communities as well:
- Door Closer Repair in Marion
- Door Closer Repair in Moundville
- Door Closer Repair in Livingston
- Door Closer Repair in York
- Door Closer Repair in Butler
- Door Closer Repair in Eutaw
- Door Closer Repair in Greensboro
- Door Closer Repair in Demopolis
All door repair services in Uniontown · Door Closer Repair across Alabama · All Alabama service areas
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895