Whether you are near Dothan nearby, over in the AL-52 corridor, or on the the Chattahoochee River side of Taylor, it is the same coverage and the same crew.
The mix of housing here matters for door work. Older Taylor homes have wood frames and hardware worth repairing rather than replacing, while newer construction tends to have vinyl and aluminum systems where the moving parts wear out long before anything else does.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895What Taylor customers call us about
These are the sliding door repair faults we are called out to most often in Taylor. If you recognise one, the underlying cause is usually the second half of the line.
- The door stops short of the jamb by half an inchDebris packed at the end of the track, or an adjuster screw wound fully out.
- The door bounces or chatters as it movesFlat spots worn onto nylon roller wheels that have been running on grit.
- The door will not latch anymoreThe panel has settled out of square, so the hook or mortise latch no longer lines up with the keeper.
- Water on the floor after heavy rainBlocked weep holes in the sill, so the track fills and backs up over the interior lip.
- The door takes both hands to moveAlmost always flat-spotted or seized rollers, sometimes a track that has worn into a trough.
- The track has a raised lip you can catch a fingernail onAluminium track peened over by a panel that has been running on bare wheel housings.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895Why sliding door repair fails in the Wiregrass
Sandy soil here drains fast but also shifts, and blowing sand is a constant presence in sliding door tracks and screen channels.
Fine sand tracked in on feet ends up in the bottom track, where it works like a lapping compound between the roller wheel and the aluminum, and doors on sandy lots wear out roller sets two or three times faster than doors that stay clean.
Sun loading on a west-facing patio slider expands the aluminum frame through the afternoon and degrades the vinyl weatherstrip and the glazing gaskets, so the door that slides fine at nine in the morning is tight by four.
None of it is a reason to replace a door. It is a reason to use the right parts and set the door up correctly in the first place.
Local factors we account for in Taylor: blowing sand and sun and heat load — typical of the Wiregrass.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895Sliding door repair work we handle in Taylor
- Multi-panel and pocket door serviceAlignment and hardware work on stacking and pocketing patio systems.
- Roller replacementTandem steel or nylon roller assemblies matched to the door manufacturer and panel weight.
- Weatherstrip and pile seal replacementNew fin seal and bulb weatherstrip to close the gaps that let air and water in.
- Latch and keeper repairRebuilding or replacing mortise latches, hook latches and strike keepers.
- Frame squaringShimming and refastening frames that have shifted out of square.
- Glass unit replacementTempered insulated glass replacement for fogged or broken panels.
- Anti-lift and security hardwareTrack locks, foot bolts and anti-lift blocks fitted to the panel.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895How we approach sliding door repair
- Look at the whole opening, not just the doorWe check the panel, the track, the head channel and the frame for square before touching a screwdriver, because a door that is fighting the frame will eat a new set of rollers in a year.
- Get the glass out of the way safelyA patio panel is heavy and awkward. We take it out properly so the track and the roller housings can actually be seen.
- Match the hardwareSliding door rollers are not universal. We identify the manufacturer and panel weight and fit the right tandem assembly rather than the closest thing on the truck. Sandy-soil jobs get their running surfaces cleaned out thoroughly, because new rollers fitted into a gritty track will not last a year.
- Restore the running surfaceWorn track gets repaired or capped so the new rollers are not immediately damaged by the old groove.
- Level the panel, then set the heightBoth adjusters are wound together so the panel sits level and the interlock engages along its whole length, not just at the top.
- Test it the way you use itWe run the door dozens of times, check the lock engagement, and make sure it moves with one hand.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895What affects the cost of sliding door repair in Taylor
We would rather tell you what drives the price than quote a number that turns out to be wrong once we see the door. On a sliding door repair job in Taylor, the main variables are these:
- how much damage the worn track has taken before the call
- whether the frame has moved and needs shimming or refastening
- whether the fix is rollers only or rollers plus track repair
- the age of the door and whether replacement hardware is still made for it
- how many panels the system has, since three and four panel doors take longer to set
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Taylor.
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895Areas we cover for sliding door repair in Taylor
Our Taylor service area includes the AL-52 corridor and the surrounding Houston County communities, out around Dothan nearby and the Wiregrass farmland.
We also cover the nearby Houston County and the Wiregrass communities listed further down this page.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895Sliding door repair in Taylor: questions we get asked
Can you fix the lock without fixing the door?
Sometimes, but if the door has settled, a new lock will not line up with the keeper any better than the old one did. We check the panel alignment first, because a lock that will not catch is often a symptom rather than the actual problem.
What does it mean when there is water pooling in the track?
The weep holes that drain the sill are blocked. It is one of the most common causes of water on the floor inside, and it is also one of the easiest things to fix, but if it sits long enough it rusts the roller assemblies out.
Why does my sliding door work fine in winter and stick in summer?
That is a moisture and expansion problem, and it is common across Houston County. Humid months swell wood and vinyl components and expand the frame slightly, which is enough to close up clearance that was already marginal because of worn rollers.
Can a sliding door that has stopped rolling be fixed, or does it need replacing?
Almost always fixed. The frame and glass are usually fine and it is the two small roller assemblies underneath that have failed. Replacing a whole patio door in Taylor is a several thousand dollar job; rebuilding the rollers and track is a fraction of that and gets you a door that rolls better than it has in years.
Do you charge to come look at it?
We talk through the symptoms on the phone first, because a lot of sliding door problems can be narrowed down from a good description and a photo of the bottom rail. Call and we will tell you what we think is going on and what it takes to fix.
Is there anything I can do to make my sliding door last longer?
Vacuum the track rather than sweeping it, keep silicone rather than oil-based lubricant on the running surface, and check that the weep holes at the bottom of the sill are open. Oil-based products in Taylor collect dust and grit and turn into grinding paste.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895Other door repair services in Taylor
- Door Lock Repair Taylor
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair Taylor
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair Taylor
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair Taylor
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair Taylor
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Taylor
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair Taylor
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Storefront Door Repair Taylor
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Door Closer Repair Taylor
Closers adjusted, rebuilt and replaced so doors shut properly instead of slamming or hanging open.
- Automatic Door Repair Taylor
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Taylor
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Taylor
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Taylor
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Taylor
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Taylor
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Sliding Door Repair near Taylor
We cover the surrounding Houston County and the Wiregrass communities as well:
- Sliding Door Repair in Rehobeth
- Sliding Door Repair in Cottonwood
- Sliding Door Repair in Webb
- Sliding Door Repair in Ashford
- Sliding Door Repair in Cowarts
- Sliding Door Repair in Kinsey
- Sliding Door Repair in Greenville
- Sliding Door Repair in Georgiana
All door repair services in Taylor · Sliding Door Repair across Alabama · All Alabama service areas
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895